Mountfield SPIRAL, Инструкция по установке и эксплуатации

Страница: 5 / 32

INSTALLATION
Required Tools:
z
Flat blade and Phillips screwdrivers
z
Wrench no. 13
z
Hose of 32 mm dia and suitable length
(for connecting the heating system with
the fi lter circuit)
z
Hose clips for securing hose connections
A) In case you have already decided to
place the SWH system freely using the
enclosed feet, install the feet according
to Figs.1 A, B – placing the washers from
above, below the nut (fi g. 1).
B). Choose a suitable area near the pool (as
described herein before). The principle
of solar system installation using hoses
is evident from the picture shown on the
fi rst page,
1) Place the SWH system in a suitable area.
2) Connect the manual by-pass line
(if provided) the two necks of the SWH;
3) Turn the fi lter unit OFF and discon nect its
supply cable from the socket.
4) Blind, or otherwise appropriately secure,
the inlet and outlet lines, to prevent
water to leak from the fi lter unit and/or
from the pool after the hoses have been
disconnected. Disconnect the fi lter unit
outlet hose from the return nozzle.
5) Connect the outlet hose of the fi lter unit
to the hose adapter found on that end
of the manual by-pass line, from which
the hose is led up to the inlet neck of the
SWH (Fig. 2).
6) Using an additional new hose interconnect
the remaining hose adapter
of manual by-pass with the return nozzle
o the pool.
7) Check all the connections and tighten the
hose clips.
8) Remove the blinds put on according to
point 4 to make the fi lter unit passable
for water fl ow.
FIG. 1 A FIG. 1 B FIG. 2
IN
S
T
RUC
T
ION F
O
R I
N
S
T
A
L
L
A
TION AN
D OPE
R
A
TION
5
INLETNECK
OUTLETNECK
If any other method of installation employing one‘s own holders, is planned, the use of
the four fi xed assembly point (see the dimensional sketch of the SWH) is recommended.
Metal holders supplied by the SWH manufacturer can be used for SWH installation. Consult
your supplier, please, in this respect.