19
7.4 Stationary use
This tool can also be used in stationary mode.
•
Secure the cable to prevent pulling the tool off the workbench.
•
Carefully switch the tool on.
Make sure that the nozzle always points away from you and any bystanders. Make sure not to drop
anything into the nozzle.
7.5 Cooling down
The nozzle and accessory become very hot during use. Let them cool down before attempting to move or
store the tool.
•
To reduce the cooling time, set the on/off switch to position
Ⅰ
and let it run for a few minutes.
•
Switch the tool off, pull the plug from the socket and let it cool down for at least 30 minutes.
8. MAINTENANCE AND CLEANING
WARNING! Before performing any work on the appliance always pull the plug from the
socket!
8.1 Maintenance
Your Power Tool has been designed to operate over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool care and regular cleaning.
8.2 Lubrication
Your power tool requires no additional lubrication.
8.3 Cleaning
•
Keep the ventilation slots on the machine clean to prevent overheating of the motor.
•
Regularly clean the machine housing with a soft cloth, preferably after each use.
•
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may damage the plastic
parts.
9. TECHNICAL DATA
Nominal voltage
220-240 V ~ 50 -60 Hz
Input
1800 W
Air temperature / Flow
Ⅰ
: 300
℃
, 250 l/min
Ⅱ
: 550
℃
, 500 l/min
Tool with double insulation; no earth wire is required.
