18
Cone nozzle
Welding, shrink sleeving (heat concentrated over
small area)
Fish tail surface nozzle
Drying, thawing (heat spread over wider area)
Scraper
Stripping paint and varnish
•
Make sure that the tool is switched off and the nozzle has cooled down.
•
Falling down nozzle can set an object on fire. Nozzles must be mounted firmly and secure on the unit.
•
Touching a hot nozzle can lead to serious burns .Before attaching or replacing a nozzle, allow the unit to
cool down completely or use a suitable tool.
•
A hot nozzle can set a surface on fire. Place down hot nozzles only on fire-proof surfaces.
•
An incorrect or defective nozzle can lead to heat accumulation and damage the unit. Use only original
nozzles according to the table that are suitable for your unit.
7. USAGE
•
Always observe the safety instructions and applicable regulations.
•
Use only one hand to hold the tool, do not place your other hand over the air vents
Prior to operation :
•
Mount the correct accessory for the application.
•
Set the desired air temperature.
7.1 Switching on and off
•
To switch the tool on, set the ON/OFF switch to position
Ⅰ
or
Ⅱ
. Some smoke may be emitted after
switching on; this does not indicate a problem.
•
To switch the tool off, set the ON/OFF switch to position
Ⅰ
, and let it run for a few minutes. Then set
the ON/OFF switch to position 0.
•
Let the tool cool down before moving or storing it.
7.2 Temperature setting
•
Turn ON/OFF switch to
Ⅰ
/
Ⅱ
, depending on temperature you need. The heat gun will start to buzz.
7.3 Stripping paint
•
Mount an appropriate accessory.
•
Set a high air temperature.
•
Direct the hot air onto the paint to be removed.
•
When the paint softens, scrape the paint away using a hand scraper.
WARNING! Do not strip metal window frames, as the heat may be conducted onto the glass
and crack it. When stripping other window frames, use the glass protection nozzle.
WARNING! Do not keep the tool directed at one spot too long to prevent igniting the
surface.
WARNING! Avoid collecting paint on the scraper accessory, as it may ignite. If necessary,
carefully remove paint debris from the scraper accessory using a knife.
