35
Recharging the battery (see Picture C)
•
Remove the battery pack (5) from the power tool by pressing the release buttons (4) and pulling it
out.
•
Connect the charger (11) to power, indicator LED (12) will shine red.
•
Insert the battery pack (5) into the charging cradle (11), charging process will start automatically and
the indicator LED (12) will flash green during the charging.
•
When the charging is finished, the LED will shine green. Complete charging of an empty battery can
take 60 min. If recharging only partially discharged battery, the charge time is shorter.
•
When the battery is fully charged, disconnect the charging station from the power
•
Remove the charged battery after charging from the charging station to prevent it from losing its
capacity.
Meaning of LEDs on the charging station
RED LIGHT
GREEN LIGHT
MEANING
On
Off
Connected to the power
On
Flash
Charging
On
On
Fully charged
Flash
Flash
Check the batter
Flash
Off
Hi / low temperature
Power indicator
State of battery charge can be checked by the in-built LED indicator (6) when the battery is inserted in
the power tool. Power indicator is activated every time the switch next to 4 LED is pressed, and goes off
after 5 seconds. Number of the green LEDs determines the actual remaining capacity:
LED indicator (
on /
off)
Battery capacity
70% - 100%
40% - 70%
10% - 40%
0 – 10%
Information on the power
tools
The power tool uses 1/4 "hex shank bits. Also included is a Magnetic adapter for screw and bits with 6
screws.
Clamping the power
tool
Insert a 1/4 "hexagonal (10) or magnetic adapter (9) into the power tool carrier and insert the bit (10)
into the power tool carrier.
