Mountfield 4125M, Инструкция по эксплуатации, Страница: 12 / 20

12
ENGLISH
GB
Petrol is highly inflammable. Always
store fuel in containers that are made
especially for this purpose.
Only fill or top up with petrol outdoors,
and never smoke when filling or top-
ping up. Fill up with fuel before starting
the engine. Never remove the filler cap
or fill with petrol while the engine is
running or still warm.
Never completely fill the petrol tank. Leave an
empty space (= at least 2-3 cm at the top of the
tank) to allow the petrol to expand when it warms
up without overflowing.
CHECKING THE ENGINE OIL LEVEL
On delivery, the crankcase is filled with SAE 30
oil.
Check the oil level every time before using to
ensure it is correct. The machine should be
standing on level ground.
Wipe clean around the oil dipstick. Un-
screw and pull it up. Wipe off the dipstick.
Slide it down completely and tighten it.
Then unscrew it and pull it up again. Read off the
oil level. Top up with oil to the “FULL” mark, if
the level comes below it (fig. 8).
CHECKING THE TRANSMISSION
OIL LEVEL (4155H)
The transmission is filled with SAE 10W-40 oil
when the machine is delivered from the factory,
Check the oil level every time before using to
ensure it is correct. The machine should be
standing on level ground.
Read off the oil level in the reservoir (fig. 9). It
should be between the MAX and MIN marks. If
necessary, top up with more oil. Use oil SAE 10W-
40 (20W-50).
SAFETY SYSTEM
This machine is equipped with a safety system that
consists of:
- a switch on the transmission (only
4125M ).
- a switch on the break pedal (only 4155H ).
- a switch in the seat/seat bracket.
- a switch at the power take-off engagement le-
ver.
In order to start the machine, the following are nec-
essary:
- gear lever in neutral (only
4125M ).
- the break pedal depressed (only 4155H ).
- driver sitting on seat.
- power take-off disengaged.
Always check the operation of the safe-
ty system before using the machine!
With the engine running and the driver sitting on
the seat, check as follows:
- select a gear, lift your weight off the seat – the
engine must stop (only 4125M ).
- press the drive pedal so that the machine starts
to move, release the drive pedal – the machine
should stop (only
4155H ).
- engage the power take-off, lift your weight off
the seat – the engine should stop.
Do not use the machine if the safety sys-
tem is not working! Take the machine to
a service workshop for inspection!
STARTING ENGINE
1. Open the fuel cock (fig. 7).
2. Make sure that the spark plug cable is properly
in place.
3. Check to make sure that the power take-off is
disengaged.
4a. 4125M : Put the gear lever in neutral.
4b. 4155H : Do not keep your foot on the drive ped-
al.
5. Starting cold engine – put the throttle control in
the choke position. Starting warm engine – put the
throttle control at full throttle (approx. 1 cm behind
the choke position).
6. Depress the brake pedal fully.
7. Turn the ignition key and start the engine.
8. Once the engine has started, move the throttle
control gradually to full throttle if the choke has
been used.
9. When starting from cold, do not make the ma-
chine work under load immediately, but let the en-
gine run for a few minutes first. This will allow the
oil to warm up.
When in use, always operate the engine at full
throttle.