30. Glue in the
3
32
" stringers (2 on each wing side) on the 'top' of the
wing. Line them up with the outside of W9. They will overhang in the
center slightly. Trim them to fit after the wing is completed.
31. Glue the
1
16
" Balsa W25 part in place with Thick CA.
32. Remove weights, flip the wing over, and glue in the
3
32
" stringers on
the 'bottom' of the wing.
29. Weigh the wing down to keep it flat on the
spar and building tabs on the ribs. Make sure the
leading edge is straight and that all parts are fully
pressed together. Secure all joints with Thin CA.
33. Glue on the
1
8
" Balsa W18 in place, on the
front of the spar and in between the spar caps,
with Thick CA.
31
