INSTRUCTIONS FOR TOP –
MOUNTED TODDLER SEAT
(MK3)
CAUTION: SEAT MUST ONLY BE
USED WITH “FLAT-TOP” SUN
CANOPIES.
16kg MAXIMUM WEIGHT CAPAC-
ITY FOR TODDLER SEAT
INSTALLING THE SEAT
A) FIXING THE ALIGNMENT OF
YOUR EXTENDIBLE HANDLE
Tip:
Silicon
spray will free up your han-
dle to slide easily.
Note
: If your extendible handle is difficult
to adjust the height, it is likely that the ex-
tendible handle is not correctly aligned.
Remove the handle
. Place the ends of the
chrome handle against the openings at the
top of the frame (where the handle en-
ters). If these are not aligned or do not
meet the ends of the tube of the frame -
then it is not aligned correctly.
To re-align;
1) The chrome handle should meet up
evenly and enter the top of the buggy
frame easily.
2) First check whether the chrome handle
(sliders) are parallel. If it isn't then simply
expand so that it is parallel.
3) Un-dome the top 4 x domes of the sling
(2 x each side) and disconnect the sun
canopy..
4) "tweak" the buggy frame by pulling
apart the top ends of the tube (where the
handle enters), and re-check that the han-
dle meets the top of the buggy frame.
5) Return handle to the buggy frame and
re-dome baby sling. Spray some silicon
onto chrome handle.
B) INSTALLING THE TODDLER SEAT
ONTO THE EXTENDIBLE HANDLE
1) With the seat facing you, enter the ex-
tendible handle sliders into the tube brack-
ets of the seat. As described above, it is
necessary that your handle meets these
openings. If the handle doesn’t - repeat the
process described above (A).
2) Slide the handle through the toddler seat
openings (note: you will have to depress
the safety buttons on the handle to com-
plete the process).
C) INSTALLING THE TODDLER
SEAT / HANDLE ONTO THE BUGGY
1) Ensure your sun canopy is out stretched
into the sun protection position.
2) Slide the Toddler seat half way up the
handle
3) With the extendible handle now in-
stalled on the toddler seat, return the han-
dle/seat combination to the buggy.
4) Ensure the safety buttons have clicked
into the safety holes of the buggy frame,
(which is the fully extended position of the
handle).
5)
IMPORTANT
: Slide the toddler seat
down the handle so that the seats tube-
bracket’s are flush with the TOP of the
buggy frame.
NOTE: The toddler seat is required to
rest against the top of the buggy frame
for correct balance and stability. The
toddler seat must be positioned directly
over the buggies rear wheels.
6) Tighten the screw handles under the
buggy frame to secure the handle into
place.
