52
Wait for the blender to stop automatically. If you want to stop the blender before the automatic
end of the program, press on the start / stop button.
Do not shake the motor unit or the jar when the blender is in use.
When you use the pusher or the middle cap, hold the jar by its handle to avoid it falling.
When the blender is in use, do not use any other accessory than the pusher to avoid damaging
the jar.
Less than 3 minutes of mixing are enough to blend liquids for most of the recipes
For adding ingredients while blending, remove the middle cap from the lid and add the ingredients
through the feeder hole. Beware of the risk of spatter.
CAUTION:
After running one cycle in the blender for the maximum processing time, let the
blender rest for 1 minute before operating it again.
After using the blender for a maximum of three cycles, stop the appliance and leave to cool to
ambient temperature (takes about 2 hours).
The appliance is equipped with overload protection. This prevents the motor from being damaged
by overloading.
If the appliance switches off during operation, proceed as follows :
unplug and leave to cool down for approx.15-20 minutes.
Reconnect the appliance to the power supply and resume blending.
After approx 3 minutes without use, your appliance will start a stand by mode. To switch on you
appliance, press the Start/ Stop button (G)
ROUGH CHOPPING SMALL QUANTITIES
Accessories used : assembled chopper
Chop in a few seconds by pulsing: peanuts, almonds etc.
Model 1600w : quantity / max time: 140g peanuts/8s or 150g almonds/8s
