MOULDPRO TCU-200, Руководство пользователя

Страница: 7 / 42

[7]
User Guidelines
– TCU-200
12-06-2019 Vers. 003
If necessary, the company using the equipment must obligate the operating personnel to wear protective
clothing.
For all tasks having to do with set-up, start-up, operating, modification of operating conditions and operational
modes, maintenance, inspection and repair, any shutdown procedures stated to be necessary in the
operating instructions must be followed.
2.4.4 Changing the Parameters
The parameters of the control system may only be changed by personnel trained by MOULDPRO.
No parameters in the device configuration may be changed without consulting MOULDPRO.
The relevant accident prevention regulations and the generally accepted principles of safety engineering,
occupational medicine and structural engineering must be observed. The national safety regulations must
also be obeyed.
2.4.5 Residual risks
Any unauthorized modifications and changes to the temperature control unit as well as unauthorized changes
to the parameters of the control system are prohibited for reasons of safety.
If the temperature control unit is damaged, it must not remain in use; the defective part must be replaced or
repaired immediately. Only original MOULDPRO replacement parts may be used. Damage due to use of third
party parts voids any and all warranty claims.
DANGER
The temperature control unit must be rendered currentless before it is opened!
Press the main switch on the temperature control unit and unplug mains plug!
Danger due to electrical shock!
Repair leaks in the temperature control circuit (device, connecting lines, etc.) immediately.
In temperature control units that use oil as a heat transfer medium, it should be noted that oil is flammable
under certain conditions. For this reason, the temperature control unit must not be located in the vicinity of
heat sources. The thermal insulation in the device must always be kept clean. Insulation that is soaked with
thermal oil poses an increased risk of fire.
Burning thermal oil can be extinguished using a spray foam fire extinguisher, a powder fire extinguisher
(avoid with dust-sensitive plants, control systems, EDP, etc.) or a CO
2
fire extinguisher. The appropriate fire
extinguisher must be provided by the operator, taking into account the equipment located in the room and the
mandatory safety regulations.
The temperature control unit may only be operated when all safety systems are completely installed and
intact. The temperature control unit must be protected against sprays and cleaning agents.