28
Base settings
close to the base during the registration process. Handsets that were supplied with your T2
base are already pre-registered.
On the base:
1. Press and hold
p
for 5 seconds until you hear a beep. The base will remain in
registration mode for 90 seconds.
On the handset:
1. If the handset is not register to a base press
m
and then enter the 4 digit PIN code
(default = 0000) and press
m
.
2. If the handset is already register to a base press
m
, scroll
d
to
ADVANCED SET
and
press
m
.
3. Scroll
d
to
REGISTER
and press
m
.
4. The display will ask for the PIN to be entered. Enter the 4 digit PIN code (default =
0000) and press
m
. You will hear a beep if the registration is successful. The handset
is automatically assigned an available handset number. Use this number when making
internal calls.
NOTE
If registration is not successful the first time, please repeat the process again in case the
base registration period ran out of time. If the base is not found after a few seconds, the
handset returns to standby. Try registering again.
If there are already 4 handsets registered to the base, the registration will fail. You must
de-register another handset before you can register a new one.
8.8 De-register a handset
Use one handset to de-register another. You cannot de-register the handset that you are
using.
1. Press
m
, scroll
d
to
ADVANCED SET
and press
m
.
2. Scroll
d
to
UNREGISTER
and press
m
.
3. Enter the 4 digit PIN code (default = 0000) and press
m
.
4. Scroll
u
or
d
to select the handset number that you want to de-register and press
m
.
You will hear a confirmation beep and the display will return to the previous menu.
8.9 Restore default settings
You can restore your T2 to its default (original) settings.
All the handsets that are registered to the base will be retained.
IMPORTANT
Resetting your phone to its default settings will delete all entries in the Calls and Redial
lists. All handset and base settings will also be reset. Entries stored in the phonebook will
Содержание T101
Страница 37: ... This page has intentionally been left blank ...
