RFS4011 Series Integrated Services Controller:
Installation Guide
24
.
4.8 Resetting the RFS4011’s Password
The RFS4011 has a means of restoring its password to its default value. Doing so also reverts the
access point’s security, radio and power management configuration to their default settings. Only an
installation professional should reset the access point’s password and promptly define a new
restrictive password.
To contact Motorola Support in the event of a password reset requirement, go to
http://www.symbol.com/contactsupport
.
4.9 Verifying the Installation
View the LEDs on the front panel of the RFS4011 Series Integrated Services Controller to ensure the
device is functioning properly. The normal LED pattern follows this path:
•
During the Power On Self Test (POST), the System 1 and System 2 LEDs both blink green.
•
If the POST test fails, the System 1 LED will blink amber. If the POST test succeeds, the System
1 LED will be lit solid green.
•
As the software is initialized, the System 2 LED will blink green.
•
After the software has finished initializing, the System 1 LED will be lit solid green and the
bottom System 2 LED will be off. The RFS4011 Series Integrated Services Controller is ready to
be configured, as described in the
RFS Series Integrated Services Controller WiNG System
Reference Guide
.
Other LED codes indicate the presence (or absence) of different standby states, or errors. A guide to
the RFS4011 Series Integrated Services Controller LEDs codes is provided in
Chapter 3, LED Codes
.
WARNING!
An improper shutdown can render the RFS4011 Series Integrated
Services Controller inoperable such that it could require service by
Motorola Support. Do not remove AC power without first following the
shutdown procedure. An abrupt loss of power can corrupt the
information stored on the device.
CAUTION
Only a qualified installation professional should set or restore the
access point’s radio and power management configuration in the
event of a password reset.
!
RFS4000_Baseline.book Page 24 Tuesday, September 28, 2010 9:55 AM
