14
6880904Z68-O
May, 1997
Operation
P110 16-Channel Portable Radios
Operation
To Power-Up
Rotate the volume control 1/2 turn clock-
wise to turn on the radio. A power-up
alert tone is generated for approximately
1/8 second to indicate that the radio has
passed a self-test of the microcomputer.
NOTE
If the short power-up alert tone is not gener-
ated, or if a second low alert tone is generated
(indicating corrupted radio programming), turn
the radio off, check the battery (charge or
replace if necessary), and turn the radio back
on again. If the power-up alert tone is still not
generated, a fault exists in the radio. Contact
your local Motorola Radius dealer.
To Receive
1.
Set the channel selector to the
desired channel position.
2.
Listen for a transmission and adjust the volume control
to a comfortable listening level. If no transmission is
heard, depress and hold the volume control button to
unsquelch the radio and adjust the volume to a com-
fortable listening level.
3.
The radio is now set to receive all calls on the selected
frequency.
4.
If you wish to monitor a channel (disable PL/DPL) press
the side mounted control button. If programmed as a
Monitor Button, the LED glows yellow for 4 seconds to
confirm that the coded squelch is disabled. Any time
the PTT button is pressed when the P110 radio is in the
monitor mode (disable PL/DPL), the LED temporarily
glows yellow to remind you that this state is active. The
radio remains in the monitor mode until the control but-
ton is pressed again, to reverse the state.
