Motorola PEBL U6, Руководство по обслуживанию

Страница: 66 / 78

66 March 06, 2006 6809493A67-O
Troubleshooting U6 GSM
4. Incoming call alert transducer audio
distorted or volume is too low.
Faulty transceiver board assembly.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared and
reassemble with the new transceiver board
assembly.
5. Telephone transmit audio is weak
(usually indicated by called parties
complaining of difficulty in hearing voice). a) Microphone connections to the
transceiver board assembly
defective.
Gain access to the microphone as described in
the procedures. Check connections. If
connector is faulty proceed to c; if the connector
is not at fault, proceed to b.
b) Microphone defective.
Gain access to microphone. Disconnect and
substitute a known good microphone. Place a
call and verify improvement in transmit signal as
heard by called party. If good, reassemble with
new microphone. If microphone is not at fault,
reinstall original microphone and proceed to c.
c) Transceiver board assembly
defective.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared and
reassemble with the new transceiver board
assembly.
6. Receive audio from earpiece speaker is
weak or distorted. a) Connections to or from transceiver
board assembly defective.
Gain access to the transceiver board assembly
as described in the procedures. Check flex and
the flex connector from the flip assembly to the
transceiver board assembly. If flex is at fault,
replace flip assembly. If flex connector is at
fault, proceed to d. If connection is not at fault,
proceed to b.
b) Flip assembly defective.
Temporarily replace the flip assembly with a
known good assembly. If fault has been cleared,
reassemble with the new flip assembly. If fault
not cleared, proceed to c.
c) Antenna assembly defective.
Check that the antenna is installed correctly. If
the antenna is installed correctly, substitute a
known good antenna assembly. If this does not
clear the fault, reinstall the original antenna
assembly and proceed to d.
d) Transceiver board assembly
defective.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared and
reassemble with the new transceiver board
assembly.
7. Telephone will not recognize or accept
SIM.
a) SIM defective.
Check the SIM contacts for dirt. Clean if
necessary and check if fault has been cleared.
If the contacts are clean, insert a known good
SIM into the telephone. Power up the phone
and confirm that the SIM has been accepted. If
the fault no longer exists, replace the defective
SIM. If the SIM is not at fault, proceed to b.
b) Transceiver board assembly
defective.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared and
reassemble with the new transceiver board
assembly.
8. Phone does not sense when flip is
opened or closed (usually indicated by
inability to answer incoming calls by
opening the flip, or inability to make
outgoing calls).
a) Flip assembly defective.
Temporarily replace the flip assembly with a
known good assembly. If fault has been cleared,
reassemble with the new flip assembly. If fault
not cleared, proceed to b.
Table 3. Level 1 and 2 Troubleshooting Chart (Continued)
SYMPTOM PROBABLE CAUSE VERIFICATION AND REMEDY