MINILINE
1000 3
MLK Amplifier Installation Sheet
DANGER!
When the power supply cover is removed, high-voltage components are exposed.
Installing the MLK
To install the MLK:
1
Use the two machine screws to install the two mounting brackets on the back of the
amplifier. Use the threaded holes that best match the mounting surface.
2
Use the two sheet-metal screws to secure the MLK brackets to the mounting surface.
3
Connect the input coaxial cable to the input connector on the bottom left of the MLK (item
10 in Figure 3). See Table 1, Key 10 for possible types of connectors.
4
If applicable, use a 2 mm Allen wrench to torque the center-conductor seizure screw to 6.5 to
9 in-lbs (0.5 to 0.75 N
•
m
)
. See Table 1, Key 9 for description.
5
Connect the output coaxial cable to the output connector on the bottom right of the MLK
(item 14 in Figure 3). See Table 1, Key 14, for possible types of connectors.
6
If applicable, use a 2 mm Allen wrench to torque the center-conductor seizure screw to 6.5 to
9 in-lbs (0.5 to 0.75 N
•
m
)
. See Table 1, Key 15 for description.
7
Applying power:
If using Model MLKL, completion of Steps 3 and 4 provide system cable power (24 Vac
to 65 Vac) to the amplifier.
If using Model MLKM, system cable power is not available and the attached power cord
(item 8 in Figure 3) must be connected to utility power (220 Vac to 230 Vac, 50/60 Hz).
8
Attach the ground lug to any of the threaded holes on the back of the MLK using the
machine screw provided.
9
Crimp the solderless connector to a suitable wire and slip over the flat on the ground lug.
10
Connect the other end of the wire to ground.
