LX2
plus / advanced and LX4 plus / advanced
B2270901
Content is subject to change without notice!
15
4
Disassembly/ Assembly Of The Pager
4.1
LX2
plus
/ LX2
advanced
4.1.1
Removing / Replacing The Battery
•
Slide the door lock away from the battery door.
•
Slide the battery door until the locking tabs release.
•
Lift the door up to open and remove the battery.
•
Replace the battery with correct polarity ( + and – markings).
•
Press down and slide the battery door until it is fully closed. Slide the door lock to its
fully locked position.
4.1.2
Removing/ Replacing The Battery Door And Back Housing
•
Remove the battery and hold the door open.
•
Apply a horizontal force, pull sideways and remove the door (refer to Fig. 1).
•
Use a slotted screw driver or similiar to slide both ends of the latch a few millimetres
away from the metal pin (refer to Fig. 2) Now lift up the ends of the latch away from the
housing. Carefully pull the latch according to the arrow shown in Fig. 3 until it is free.
•
Separate the back housing from the front housing (refer to Fig. 4).
To replace the back housing, align it with the front housing and press back together.
The metal pin (for the carrying chain) has to be pushed into the respective hole of the
back housing.
•
Start replacing the latch at the side opposite to the charging contacts (refer to Fig. 5),
place the studs into the zip-holes around the housing (as shown in Fig. 6).
•
Align the battery door hinges with the hinge slots on the back housing and push to en-
gage the hinges (refer to Fig. 7). The battery door is properly seated when it can be
lifted up and closed easily.
4.1.3
Removing/ Replacing The Receiver Board
•
Remove the battery.
•
Remove the battery door, the latch and the back housing.
•
Gently pry the receiver board up and away from the decoder board (refer to Fig. 8).
•
To replace the receiver board, align the interconnect socket on the receiver board with
the interconnect plug on the decoder board and press the receiver board down. Do not
misalign the shock pad.
•
Replace the back housing, the latch and the battery door.
•
Replace the battery.
Fig.1
Fig. 2
