6
•
Please make sure that these components are present before you begin the unit installation. If components are
missing or damaged, contact the store where you purchased the unit immediately.
STEP2. Place the Phone
•
Place the phone on a stable flat secure surface area (desk, table, etc.). Serious damage may result if the unit
falls. Do not place the unit on, or within 1 meter of heaters or radiators. This unit is designed for desktop usage.
Avoid direct exposure to sunlight and damp area.
•
Read the SAFETY INFORMATION located at the end of this manual you place the phone.
STEP3. Connect Components (See the figures in “Installation Steps”.)
•
Connect antenna to the antenna connector located at the right side of the phone. If you have placed the phone
on the flat surface, bend the antenna up right.
•
Connect curl cord of handset to the RJ-11 port located at the left side of the phone.
•
Open the battery case and install the batteries, then close the case.
•
Connect the AC/DC Adapter cable to the DC port located at the back of the phone.
•
Please follow steps below to get better voice quality:
1.
Keep the phone away from electrical appliances such as TV, computer, radio and so on.
2.
Keep the phone in a high and central location with no obstructions, such as metal walls.
3.
Raise the integral antenna of phone to get maximum strength of receive signal as shown in the
figure in the next page.
STEP4 Check the LCD Display
•
After you follow the installation instruction STEP 3, please check the LCD for normal operation
•
If you do not see the status of service, please repeat the instruction of STEP 3 and confirm the fixed wireless
phone to have the proper signal strength from tha carrier.
