Getting Started
13
ENGLISH
2.3
Monitor Unit Power Supply
IMPORTANT
Installing the rechargeable battery pack and charging it fully before use is
recommended. This will allow the unit to operate on battery in the event of a
power failure.
1.
Connect the small plug of the power adapter to the Monitor unit and the
other end to the electrical outlet. Only use the enclosed power adapter
(6V DC/500mA).
2.
Press and hold the
P
POWER ON/OFF button for 1 second to turn ON
the Monitor unit.
3.
Once the Camera and Monitor units are switched on, the display on the
Monitor unit will show the video captured by the Indoor Camera Unit.
4.
If there is no connection or you are out of range, the video display will go
off and
will be shown on the LCD display, and the unit will beep every
5 seconds. Move the Monitor unit closer to the Indoor Camera Unit until
the link is re-established.
5.
Press and hold the
P
POWER ON/OFF button, until the progress bar
finishes scrolling, to turn OFF the Monitor unit.
NOTE
The battery icon
0
turns RED to indicate that the battery is low, and it gives
a beep every 16 seconds. The battery needs to be recharged. The battery pack
takes about 16 hours to be fully charged.
When charging
1.
During power OFF, when adapter is plugged in, an adapter logo will
display on screen and then a flashing battery logo will display for 45 sec.
The Blue LED at top left corner light up indicates that the adapter is
plugged in.
