10
EX-3524/EX-3548 Layer 2 Gigabit Ethernet PoE/PoE+ Switch
2.5.1 Port LEDs
For information on port status LED indicators, see
Port Status LEDs on page 13
.
2.5.2 10/100/1000BASE-T RJ-45 Ports
The switch contains 24 10/100/1000BASE-T RJ-45 ports that support 10/100/1000BASE-T copper links to other
devices. For more information, see
Connecting Twisted-Pair Cables on page 20
.
2.5.3 Gigabit SFP Slots
The switch contains four Small Form Factor Pluggable (SFP) transceiver slots that operate up to Gigabit full duplex.
For more information, see
Connecting to SFP Ports on page 22
.
2.5.4 Mode Button
Pressing the Mode button on the front panel will change the Diag LED to display PoE status. For more information,
see
LED Codes on page 12
.
2.5.5 Console Port
The RJ-45 connector on the front panel far right side that is labeled “Console” provides an out-of-band serial
connection to a terminal or a PC running terminal emulation software. The port can be used for performing switch
monitoring and configuration. For more information, see
Connecting to the Console Port on page 24
.
2.5.6 System LEDs
For information on system status LED indicators, see
LED Codes on page 12
.
2.5.7 Reset Button
Pressing the reset button on the rear panel causes the switch to execute a hard reset. For more information, see
Resetting the Switch on page 26
.
2.5.8 Ground Point
The switch should be connected to ground using this screw connection. For more information on how to connect
ground to the switch, see
Power and Grounding on page 18
.
