Motorola CPV5000, Инструкция по установке и справочник

Страница: 94 / 144

Power On Self-Tests
6-4
6
AMIBIOS displayed error messages
The following section describes the operation of the CPV5000 when the BIOS
detects an error during power up of the CPV5000. The explanation assumes
that a copy of AMI diagnostics is available to assist with debug of the problem.
If an error occurs after the system display initializes, error messages are
displayed as follows:
ERROR Message Line 1
If this message appears, press <F1> to continue.
The following message may also appear:
RUN SETUP UTILITY.
Press <F1> to run WINBIOS Setup if this message appears. Refer to Table 6-
3 for AMIBIOS displayed error message information.
Table 6-3. AMIBIOS error messages
Message Explanation
8042 Gate-A20 error Gate A20 on the keyboard controller (8042) is not working. Replace the
8042.
Address line short! Error in the address decoding circuitry
C: drive error No response from drive C:. Run the AMIDiag hard disk utility. Check
the C: hard disk type in Standard Setup.
C: drive failure No response from hard disk drive C:. Replace the drive.
Cache memory bad,
Do not enable cache Cache memory is defective. Run AMIDiag.
CH-2 timer error An AT system has two timers. There is an error in timer 2.
CMOS battery state
low CMOS RAM is powered by a battery. The battery power is low. Replace
the battery.
CMOS checksum
failure CMOS RAM checksum is different than the previous value. Run
WINBIOS Setup.
CMOS system options
not set The values stored in CMOS RAM are destroyed. Run WINBIOS Setup.