Installing a Board
http://www.motorola.com/computer/literature
1-17
1
3. Ensure that the two handles are in the outward position.The CPIP5430
ejector handle is a Rittal Type IV (C) and has a red tab or button on the
lever. Push the red button and press the ejector lever outward.
4. Verify the proper slot for the module you are inserting. Orient the
board and align it with the black card cage rail guides.
5. Insert the board by holding the ejector lever — you may need to gently
press on the upper faceplate to help insert the board in its slot.
Apply equal and steady pressure using your thumb if necessary to
carefully slide the module into the card cage rail guides. Continue to
gently push until the prealignment guide pegs engage in the backplane
connector receptacles (Stage 2) and the ejector handle makes contact
with the chassis rails. DO NOT FORCE THE BOARD INTO THE
BACKPLANE SLOT.
6. Use the ejector lever to seat the module in the slot by closing the lever
inward until it is in the horizontal, locked position (Stage 3). There
should be a “click” upon successful insertion. If the handles do not
completely latch, remove module from chassis and visually inspect the
slot to ensure there are no bent pins.
7. When the module you are installing is completely latched, secure it by
tightening the captive screws at the top and bottom of the panel.
