Motorola CP110 UHF, Руководство пользователя

Страница: 38 / 138

PROGRAM
MI
NG
FEATURES
English
36
Entering Programming Mode
Note: To enter ‘Programming Mode’, long press
both the PTT and the SB1 button
simultaneously while turning ON the radio
for 3 to 5 seconds until a ‘chirp’ sounds. You
will have entered into ‘Idle Programming
Mode’ (*), and the LED Indicator will start
blinking a green heartbeat.
To read or modify Codes and Auto-Scan, set
the radio to ‘Programming Mode’ by long
pressing both the PTT and the SB1 button
simultaneously while turning ON the radio for
3 to 5 seconds until a ‘chirp’ sounds to indicate
that you have entered ‘Idle’ Programming
Mode (*).The LED Indicator will start blinking
a green heartbeat.
Note: (*) ‘Idle’ Programming Mode is the stage of
the Programming Mode in which the radio is
waiting for the user to start the radio
programming cycle (refer “Entering
Programming Mode” on page 34)
Once you are in ‘Idle’ Programming Mode,
short press the PTT button to move along the
different programmable features.
Frequencies Values
Frequencies values can only be read via the
CPS.
Reading CTCSS/DPL Values
If you continue short pressing the PTT button
as shown in
Figure 1 : Entering Programming
Mode on page 34 (stage 2), the radio will move
forward to programming CTCSS/PL Codes.
When reading the values for CTCSS/PL Codes
the radio signals you the digit codes each time
you short press the PTT button.
You will have to read three digits as CP110™
Series have up to 122 codes available (refer to
“Frequencies and Codes Charts” Section).