Motorola C4201H, Руководство пользователя, Страница: 5 / 20

5 Getting started
1.4 Battery and Charging
BATTERY LOW WARNING
If you hear a warning beep every 2 minutes during a call, you will need to recharge the
handset before you can use it again.
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give up to 16 hours talk time or up to 200
hours standby time on a single charge.
1
Note that new batteries do not reach their full capacity until they have been put to normal
use for several days.
To keep your batteries in the best condition, leave the handset off the charger for a few
hours at a time.
Running the batteries right down at least once a week will help them last as long as
possible.
The charge capacity of rechargeable batteries will reduce with time as they wear out,
giving the handset less talk / standby time. Eventually they will need to be replaced.
After charging your handset for the first time, subsequent charging time is about 6–8 hours
a day. Batteries and handset may become warm during charging. This is normal.
1 All talk and standby times are approximate and depend on features selected and usage
pattern.
1.5 Registration
1.5.1 Registering an additional handset
You can register up to 4 handsets to your C42 main base to extend your phone system
without having to install extension sockets for each new phone.
You must register C42H to your C42 base before it can be used.
NOTE
Handset batteries must be fully charged before you start to register. Hold your handset
close to the base during the registration process.
On the C42 base:
1. Press and hold
P
for 5 seconds until you hear a beep. The base will remain in
registration mode for 90 seconds.
On the C42H handset:
1. If the handset is not register to a base press
m
and then enter the 4 digit PIN code
(default = 0000) and press
m
.
2. If the handset is already register to a base press
m
, scroll
d
to Services and press
m
.
3. Scroll
d
to Register and press
m
.
4. The display will ask for the PIN to be entered. Enter the 4 digit PIN code (default =