3. Connect power using one of the following methods:
l
Power over Ethernet (PoE) Plus IEEE 802.3at Class 4 — Connect a PoE Plus compliant injector
or switch to the Ethernet network cable.
l
60 W PoE Injector (POE-INJ2-60W) — Connect an Ethernet network cable to the injector.
l
Cisco® UPoE capable switch, supporting 60 W over 4 pairs. Note that the Cisco switch must be
configured with the
Force Four Pair
option enabled.
l
External Power — Connect an auxiliary power source that supports up to 60 W.
For more information, see
.
4. Connect a network cable to the Ethernet port (RJ-45 connector).
The Link LED indicator will turn on once a network link has been established.
5. Check that the Connection Status LED indicator indicates the correct state. For more information, see
Connection Status LED Indicator
Securing the PTZ Dome Camera
After the cable connections have been made, secure the PTZ dome camera to the mount.
1. Attach the dome to the NPT adapter.
a. Push the PTZ dome camera into the 1 1/2” NPT mount adapter.
Note:
Be careful not to trap any cables between the dome camera housing and the
mount adapter.
b. Once the dome is aligned to the NPT adapter, turn the dome until it locks into place.
2. Use the Torx key provided with the dome camera to tighten the screws in the mount adapter.
Adjust the NPT adapter as needed to reach all the screws.
Securing the PTZ Dome Camera
10
