Motorola AP-0622, Руководство по установке

Страница: 17 / 40

Installation Guide 17
2.8 External Antenna Suspended Ceiling Tile (Plenum) Mount
Ceiling mount requires placing the AP-0622 access point above suspended ceiling tile.
2.8.1 Suspended Ceiling Mount Hardware
• Security cable (optional)
• Mounting ears
• Customer supplied pipe or channel clamps
2.8.2 Ceiling Mount Procedure
1. If possible, remove the ceiling tile from its frame and place it, finish side down, on a work surface.
2. If required, install and attach a Kensington security cable (customer provided) to the unit’s lock port.
3. Place the access point on the ceiling tile or attach to a plenum beam or pipe using industry available clamps.
4. Attach appropriate antennas to the connectors.
5. Bring the tile into the ceiling space
6. Attach an Ethernet cable from the access point to a controller with an 802.3af compatible power source or use
the PWRS-14000-148R power supply to supply power to the AP-0622 (once fully cabled).
7. Verify the access point is receiving power by observing the LEDs.
8. Place the ceiling tile back in its frame.
NOTE
Notes or warnings about suspended ceiling mounts apply to all
installations where the unit is placed on suspended ceiling tile.
CAUTION
Motorola Solutions does not recommend mounting the AP-0622
access point directly to any suspended ceiling tile with a thickness
less than 12.7mm (0.5in.) or a suspended ceiling tile with an
unsupported span greater than 660mm (26in.). Motorola Solutions
strongly recommends fitting the AP-0622 access point with the
supplied mounting ears and hanging the access point on a pipe or
beam.
CAUTION
If not using a 802.3af capable controller to power the AP-0622, ensure
only the AP-0622’s designated power supply (PWRS-14000-148R) is
used to supply power to the access point. Using an incorrectly rated
power supply could damage the unit and void the product warranty.
Do not actually connect to the power source until the cabling portion
of the installation is complete.
!
!