8
4
870 mm
1
2
870 mm
Remove
the screws
Install the wall
mounting screws
3
4
•
Remove the battery from the remote
control when not in use for a long
p e r i o d o f t i m e , a s c o r r o s i o n o r
battery leakage may occur and result
in physical injury, and/or property
damage, and/or fire.
•
Do not use any batteries other than
those specified.
•
Do not mix new batteries with old ones.
•
Never recharge a battery unless it is
confirmed to be a rechargeable type.
5. Placement and Mounting
5.1
Placement
A
B
A If your TV is placed on a table, you
can place the unit on the table
directly in front of the TV stand,
centered with the TV screen.
B If your TV is attached to a wall,
you can mount the unit on the wall
directly below the TV screen.
5.2
Wall Mounting
1.
Drill 4 parallel holes (Ø 5.5-6 mm
each according to wall type) in the
wall. The distance between the holes
should be 870 mm.
2. Firmly fix 1 dowel into each hole in
the wall if necessary. Tighten the
wall mount brackets on the wall
with screws and screwdriver (not
included). Make sure that they are
securely installed.
3. Remove the screws at the back of the
unit. Install the wall mounting screws
into the back of the unit.
4. Lift the unit onto the wall mount
brackets and slot into place.
-
Installation must be carried out by
qualified personnel only. Incorrect
a s s e m b l y c a n r e s u l t i n s e v e r e
p e r s o n a l i n j u r y a n d p r o p e r t y
damage (if you intend to install this
product yourself, you must check for
installations such as electrical wiring
and plumbing that may be buried
inside the wall). It is the installer’s
responsibility to verify that the wall
will safely support the total load of
the unit and wall brackets.
