6A
6B
A
C
B
A
A
D
D
E
E
G
G
M
M
SIGNED
NAME
B
A
C
1
2
3
≈3cm
EN
EN
04. INSTALLATION
AUTOMATISM INSTALLATION
MICROS ADJUSTMENT
04. INSTALLATION
1 • Place the motor on the support plate and
fix it with supplied M8 screws.
The arms are supplied already assembled.
•
If you install only one motor and the arm is not in
the correct position, you can easily change the direc-
tion following the indications in the picture
Fig. 13
.
1 • Mount the square hole in the motor's output shaft, and tighten with provided washer and M10x20
screw. 2 • Place the other extremity of the arm under the gate support, and secure with screw, bushing,
washer, and female.
1 • Unlock the automation and open the door leaf to the desired position.
2 • Loosen
(A)
the
opening ring screw
, and turn it
(B)
until you hear a *click* of the micro switch.
3 • Tighten the screw
(C)
of the ring to lock it in this position.
ARMS INSTALLATION
Remove the automation's
cover. To do this, loosen the
two front screws, slightly tilt
the cover back and pull up.
After the installation is complete, make all the electrical connections and replace the cover.
Fig. 11
Fig. 14
Fig. 12
Fig. 13
Fig. 16
Fig. 17
Fig. 18
4 • Close the door leaf, loosen
(A)
and turn
(B)
the
closing ring
until it makes a *click* into the corres-
ponding micro. Retighten
(C)
the ring screw.
5 • Manually test the opening and closing of the gate
to ensure that the micro switches are activated in
the correct point. 6 • When the micros are tuned, re-
-lock the automation.
Fig. 19
Fig. 20
Fig. 21
Fig. 22
Fig. 15
