4A
4B
Supply: 100-240vac 50-60hz
Output: 100-240vac 50-60Hz
Watts: 750W max.
Frequency: 433Mhz
IP 44
CL
COM
MO
TOR
OP
L
N
90-230
Va
c
EN
EN
02. CHANGE MOTOR DIRECTION
CONNECTIONS SCHEME
230V
Motor
Antenna
CLOSE (black/brown)
OPEN
(black/brown)
COMMON
(blue)
03. THE CONTROL BOARD
TECHNICAL CHARACTERISTICS
This control baord was developed for rolling motors. (Shutters, rolling grilles, blinds, etc.) Works with
230v motors with built-in radio module.
Its small size allows it to be installed in places with reduced space.
It has screwless connectors in order to increase the speed and ease of connection.
112mm
28mm
26mm
• Power supply
100-230Vac 50-60Hz
• Motor output
230Vac; 750W Max
• Built-in radio receiver
433,92 MHz
• Working temperature
-20°C to 70°C
• Number of channels
120 remote controls
• Code type
Rolling Code
• Protection range
IP44
• Fixed maximum working time per maneuver
4 min
• Box material
ABS
CN1
01 •
100-230Vac line input (neutral)
02 •
100-230Vac line input (phase)
03 •
Motor output - OPENING
04 •
Motor output - COMMON
05 •
Motor output - CLOSING
CONNECTORS DESCRIPTION
04. PROGRAMMING
PRE-PROGRAMMING INFORMATION
The control board allows the programming of two operating modes in remote controls: 1 key or 3 keys.
To know the OPEN, STOP and CLOSE keys of the various remote controls, check the following diagrams:
• TYPE OF REMOTE CONTROL PROGRAMMING
1 KEY
You can program any key on the remote control, which will send all orders to the
control board.
Example: Open - Stop - Close - Stop - Open (...)
3 KEYS
The programmed command will work with the keys:
OPEN
|
CLOSE
|
STOP
Each key will send a different order to the control panel.
OPEN
OPEN
OPEN
STOP
CLOSE
CLOSE
STOP
CLOSE
OPEN
STOP
CLOSE
ND
This control board only allows the programming of Rolling Code MOTORLINE remote controls up to a
maximum of 120 remotes controls. When programming the 121st remote control, the control board
emits 1 long beep to indicate that the memory is full.
To program the first command, you can do it through the control panel's power supply or through a
panel. When you have a command already programmed, you can use it to open the control panel's
memory remotely and program new commands.
REMOTE CONTROL PROGRAMMING
Program new remote control (3 keys):
01
•
Press and hold the
OPEN
key of the remote control you want to program.
02
•
Connect the control board to a 100-230Vac power supply.
03
• Keep the
OPEN
key pressed for 10 seconds, during which the control board emits 5 slow beeps.
04
•
After 10 seconds, the control board emits 3 quick beeps confirming the success of the programming.
Release the remote control key to finish programming the 3 keys.
05
•
If you want, you can add more remote controls for 10 seconds. If you press a remote control that has
already been programmed, you will hear long, fast beeps.
06
•
After 10 seconds without any activity, the programming exits, signaled by 3 beeps.
