9A
9B
21
22
25
26
24
23
EN
EN
Pay attention to installation dimensions mentioned on pages 6B, 7 and 8!
01
• Fixing rear support
04
• Install operator on the supports
05
• Test movement
06
• Connecting operator to control board
and configuring control devices.
02
• Fixing front support
03
• Remove caps and pins from motor
• The
Rear support
must be fixed to the
pillar or wall using dimensions provided
in the preceding pages.
It can be fixed using screws with
mechanical bushing or chemical welding
process, or one of your choice since it
provides an appropriate support.
• The operator must be placed on both
supports the same time to avoid leaving
the operator suspended by only one of the
supports.
To make the task easier, you should unlock
the operator in order to be able to stretch/
retract arm easily (see page 4B),to get the
correct position for supports.
• Install the pins removed earlier on each
place with a small amount of lubricant for
less friction.
• Move the door manually to see if the door
opens and closes uniformly and correctly,
without any irregular friction during its
entire travel;
This will ensure that operator is not
subjected to problems during operation.
• With the operator installed, connect it
to control board for system configuration
(see control board user manual).
Must also configure the desired control
devices (transmitters, wall switch, etc.)
and other additional components such
as antenna, warning light, key selector,
among others.
• The
Front support
should be fixed to the
gate, respecting height dimensions and
distance to the rear support.
This may be fixed by using screws, welding
process, or to choose another long as it
provides a secure proper support.
• Before installing motor, remove caps
and pins from motor.
• At the end of the installation, put back
plastic covers for a better visual finish of
the operator.
It is important to respect this installation order!
Otherwise, it is not possible to ensure correct installation and operators may not
work properly!
04. INSTALLATION
04. INSTALLATION
INSTALLATION STEPS
INSTALLATION STEPS
