6
7
SAVE THESE INSTRUCTIONS.
INSTALLING OR REMOVING THE USB
CARTRIDGE
To install the USB cartridge (a), align the tongue on the USB cartridge with the groove on
the battery and slip it into place. Insert it all the way until it locks in place with a little click.
Ensure the USB cartridge is locked into place before use.
Do not install the USB cartridge forcibly. If the cartridge does not slide in easily, it is not
being inserted correctly.
To remove the USB cartridge, slide it from the product while pressing the button (b) on the
front of the battery.
CONNECTING A USB DEVICE
CAUTION: Connect only devices which are compatible with DC5V, 1.0A or 2.0A power
source to the USB power supply port. Otherwise it may cause malfunction to the product.
Press the power button on the USB cartridge to turn the on/off switch (d). The indicator
light will illuminate green. Connect the USB cable (not included) with the USB port (c) and
then connect the other end of the cable with the device you wish to recharge. The indicator
light will flash green while the device is charging. When the device has finished charging
the indicator light will stay green for 5 minutes. Press the power button on the USB on/off
switch to turn the cartridge OFF.
Note: The USB cartridge will automatically turn off after 10 minutes if no device is plugged
into the USB ports.
NOTE
Before connecting USB device to the product, always backup your data of the USB
device. Otherwise your data may lost by any possibility. The seller is not responsible of
any kind of data loss.
The product may not supply power to some USB devices.
Do not insert a nail, wire, etc. into USB power supply port. Otherwise a circuit short may
cause smoke and fire.
Wait for 10 seconds before charging another device consecutively.
On rare occasions, the tool may not start charging due to the protection system to
reduce battery consumption. In that case, remove the USB cable, and reconnect it after
approximately 10 seconds.
TECHNICAL SPECIFICATION
Ports
2 (USB A type)
Output voltage
Output current
Compatible batteries
5V DC
1.0A / 2.0A
MH-03-B-B1-20V2AH-1&MH-03-B-B1-20V4AH-1
The rating plate on your tool may show symbols. These represent important information
about the product or instructions on its use.
Read the instruction manual.
This product is suitable for indoor use
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or
retailer for recycling advice.
SYMBOLS
ACCESSORIES
If you need accessories for use with your tool, most recommended accessories are
available online through major retailers and MOTORHEADTOOLS.COM. If you need accesso
-
ry information, please call: 1-866-608-5212.
WARRANTY
FULL TWO YEAR HOME USE WARRANTY
FULL TWO YEAR HOME USE WARRANTY
MOTORHEAD warrants this product for two years against defects in materials and assem-
bly. This LIMITED WARRANTY does not cover products that are improperly used, abused,
altered or repaired by unauthorized personnel.
This warranty does not apply to accessories. This warranty gives you specific legal rights
and you may have other legal rights which vary from state to state or province to province.
For warranty questions, replacement, or repair, call American Customer Service at
1-866-608-5212.
This product is not intended for commercial use
Register your product at www.motorheadtools.com for a free extended warranty and
20V ULTRA USB Power Source Adapter
(MH-03-BA-B1-USB-1)
20V ULTRA USB Power Source Adapter
(MH-03-BA-B1-USB-1)
