50
Manuale Uso e Installazione
–
Operating and Installation Manual
SKA COMPACT e SKA DDL Linear Stage
Revisione 02 20092019 Doc.7.3.15
11.3
SKA DDL Linear Stage assembly surface
The motor must be supported by an adequately prepared surface to accommodate the SKA DDL
Linear Stage motor. The size of this surface must be calculated to cater for the weight of the
motor and the parts that will be mounted on it and precision machined to ensure the motor
supports rest on it perfectly (maximum error of flatness 0.2 mm).
If the full length of the motor is not mounted on a flat surface but on a frame or other structure,
the points supporting the motor must still have a flatness of 0.2 mm and all the support and fixing
points required must be provided.
11.4
SKA DDL Linear Stage mechanical installation
After unpacking, the SKA motor must be placed on the surface provided as described in the
paragraph above and secured to it using steel screws.
Use all the holes provided to secure the motor and appropriate steel screws at each point of
attachment.
These screws must secure the motor firmly; tighten by applying the torque settings listed in Table
1 and block using medium threadlock (such as Loctite 243).
Release the moving table by removing the appropriate lock and slide it by hand along the axis for
its entire length, checking that the movement is smooth, that there are no parts knocking the
table and that it trips the electrical safety limit switches before coming into contact with the end
bumpers.
Now complete the electrical wiring of the motor using the connectors on the base and the
performance tests: first with no load, then with no load mounted on the table, as described in
Chapter 4.5 below “Electrical Installation of SKA motors”
.