7.2 Stopper Pin
7-3
HS0481357
HS0481357
7.2
Stopper Pin
In the operation of the MOTOPOS-1000, operators may directly set/remove workpieces in/
from the jig on the table.
To prevent injury in such occasions, the table can be mechanically locked with a stopper pin to
stop its rotation. Using an air cylinder, insert the stopper pin into the hole on the rotary side
with the rotary axis positioned at +90° and -90°.
Note that they cannot be used for positioning since there is a 3-mm gap between the pin and
the hole. Refer to " 8.2 Internal Connections " for the wiring.
Fig. 14 Minus Cable Connection
Hole
Block (rotary side)
Stopper pin (fixed side)
Air cylinder
