Quick Start:
–
Connect the sensor and phase cables to the motor (A, B and C respectively). The
connection on the Motolyser side is shown in Figure 2.
–
Connect the supply battery (1 or 2-cell Li-Po)
–
Navigate to Motor Current or Condition Test by using the UP/DOWN touch buttons
–
Push right touch button (ENTER), see figure 1
–
When the test is completed step amongst the result screens with the UP/DOWN
buttons, or EXIT to go back to main menu
Main Menu
To navigate in the menus and to start the motor the touch buttons are used. There are four
buttons integrated that are used for navigating the menus. Push ENTER to select an item
and EXIT to go back to main menu.
Current Test:
Starts a quick test for measuring how the motor operates when
running with end-bell timing.
Condition Test:
This is the Traditional Motolyser test for measuring sensor and
magnet condition.
Sensor Status:
Shows the status of each sensor element, to verifying sensor
function.
Supply Voltage:
Show the voltage of the supply battery.
Firmware Upgrade:
Enters the firmware upgrade mode, for connection to the PC
upgrade application using the USB port.
System Info:
Displays the hardware version, manufacturing date, and FW
build.
Sensor Status
2014-10-05 [Ver 1.2]
www.motolyser.com
2/6
