Yamaha Grizzly 550/700
Winch Mount Kit
MA11927
23001 Industrial Blvd Rogers, MN 55374
866.527.7637 (toll free) 2 [email protected]
FIGURE FOUR
FIGURE FIVE
FIGURE SIX
FIGURE SEVEN
Appendix to Electrical Installation (if
necessary)
Hook Up the Electricity
1. The next step is to install the contactor (control
relay). There is no right or wrong place. We
recommend a dry place away from sharp or
moving suspension parts, knowing that it is hard to
find a totally dry place on an ATV. You may mount
it in the front or back or under the seat. In this
case we mounted it in the cargo box behind the
seat. You may mount it with U-bolts (holes on
contactor are metric) or bolts. We attached all the
wires before bolting it down. We do offer an
optional side bracket mount. This bracket allows
the contactor to hang on the side of square tubing.
There is an additional cost associated with this
part, just call us for details. See picture 5.
2. Now the power wires can be run. Take the long
set of red/black power wires and attach the red
wire to the winch’s red terminal and the black wire
to the silver terminal. Keep the wire away from
moving suspension parts. We left wire loose as we
went down the upper frame. When fastening any
wire where moisture could cause problems put
dielectric tune-up grease (Permatex 22058 from
NAPA) on all connections. Also if you want extra
vibration protection Napa has plastic split tube
conduct that can also be installed over the wire