Moto Electric Vehicles Bubble Car, Руководство пользователя

Страница: 9 / 24

9
LE SE
To engage the parking brake
Fig. 1 Step down the parking brake pedal by foot until it
’s hooked
Fig 2. Step down upper section of the parking pedal by foot until it
’s hooked.
To disengage the parking brake,
Fig. 1 Step down the parking brake pedal to the end until the parking brake pedal is unhooked.
Fig. 2 Step down lower section of the parking to the end until parking brake pedal is unhooked.
WARNING!
Please always disengage the parking brake pedal before you drive the vehicle. Failure to do this can
cause damage to the braking system of the vehicle.
Steering wheel
The steering wheel is used to control the driving direction. Please avoid any sudden movements which can
cause the vehicle to flip.
TOW/RUN SWITCH (available for Curtis 1268 controller)
Before operating the vehicle, make sure the TOW/RUN switch is on
‘RUN’ position.
Make sure the TOW/RUN switch is on the
‘TOW’ position if towing the vehicle.
The TOW/RUN switch is located under the dashboard as showed below picture.
LE SE
NOTE: When the TOW/RUN switch is on the
‘RUN’ position, the vehicle will beep if towing the vehicle.
TURN THE VEHICLE TO TOW MODE RIGHT AWAY IF YOU HEAR THIS BEEP
COMBINATION SWITCH:
Combination switch includes a left lever and a right lever: the left lever of the switch is used to switch on/off
the lighting system including the headlights, front turn signals, rear turn signals, and the taillights; the right
lever is used to control the wiper and horn.
*NOTE: The Combination Switch is NON Canceling, please return the Turn Signal Stick to the
Neutral Position when done turning!