Motive NEO-WiFi Series, Руководство пользователя

Страница: 113 / 128

113/128 NEO-WiFi – Handbuch - DE REV15-DEC18
Modbus Variables table chart
NEO-WiFi Modbus Variables (Rev. 16/12/2016)
This modbus table chart is installed in the following inverter SW versions:
NEO3
4.02 – 4.04 – 4.08
NEO11 3.01 – 3.05
NOTE:Not all the variables can be modified. In the column “Type” the letter R means “read only” and R/W means “Read and Write”
N°
Typ
e
Variable Definition UOM Lower Limit Upper Limit Note
0 R inverter power KW*10 30 220
1 R software version
2 R last revision (day+month*32+year*32*13) days 0 0xffff
3
4 R/W radio frequency-860 Mhz-860 0 19 connect SET with +15V (NEO3) / 0V (NEO11-22)
5 R/W motor code radio communication 1 15 connect SET with +15V (NEO3) / 0V (NEO11-22)
6 R/W rated power KW*100 9 2200 the value range, depends on the inverter type
7 R/W rated voltage V 180 460
8 R/W rated current A*10 6 450 the value range, depends on the inverter type
9 R/W rated frequency Hz 50 60
10 R/W rated rpm rpm 350 5950
11 R/W power factor cosφ *100 50 95
12
13 R/W maximum speed % of motor speed 50 200
14 R/W minimum speed % of motor speed 2 50
15 R/W acceleration seconds*10 1 999
16 R/W deceleration seconds*10 1 999
17 R/W maximum inrush current %In 80 200
NEO 3 KW: 150%
NEO 11 KW: 200% (7,5kW)
160% (11kW) Max
NEO 22 KW: 150%
18 R/W
rotation sense (valid with start/stop
commands
0 1
valid only when the start/stop source, is from keypad without
selector
19 R/W internal speed rpm
minimum
speed
maximum
speed
20 R/W enable electromagnetic brake 0 9044
0=OFF, 9044=ON
Before connecting the wires of the external braking resistances to
the BR + and BR- terminals, disconnect from the same terminals the
wires of the internal resistances and insulate them.
21 R/W voltage feed of the brake coil V (104V) 0 (180V) 1
22 R/W
machine code for RS485 serial
communication in group
1 35 See following tablechart***
23 R/W enable restart 0 1 0=OFF, 1=ON
24 R/W dead time after alarm seconds 1 999 restart after alarm
25 R/W start/stop source 0 2
0 = keypad button and keypad selector
1 = keypad button only
2 = External remote wired control
26 R/W speed reference 0 4
0=internal speed
1=keypad potentiometer
2=AN1 signal 0-10V
3=AN1 signal 4-20mA
4=AN2 signal 0-5V (only in speed control)
27 R/W encoder pulses/revolution integer pulses/revolution 0 9999
28 R/W encoder pulses/revolution decimal pulses/revolution/1000 0 999