Motion Simulator
MotionGear 4U
MotionHouse Co., Ltd.
8/11
Status LED display :
③
LED is composed of three types: SET, RUN, and ERR.
SET LED is on when the motion simulator power is
on and before the PC is connected.
RUN LED lights up when the motion simulator is
connected to a PC and is ready to run in an
initialized state.
ERR LED turns on when an error occurs in the
motion simulator, and at this time, the simulator no
longer moves and stops.
If the error continues, do not operate the product
※
and contact the MotionHouse to take action.
POWER button: This button is used to turn the power ON / OFF. When
④
the power is ON, the button lights red, and when it is
OFF, the light goes out and the power is cut off.
Cylinder connector: This connector is used to connect to the cylinder.
⑤
Cylinder 1EA is a set of 2 cables (motor, encoder).
Since the connector of the motor and encoder
cable are different, check and install the connector.
In addition, the connector must connect the
cylinder for each position. Be sure to refer to the
photo below to check the location and install the
connector.
Front
FL
FR
RR
RL
FL : Front Left
FR : Front Right
RL : Rear Left
RR : Rear Right
