Motion Simulator
MotionGear 4U
MotionHouse Co., Ltd.
7/11
How to operate MotionGear 4U Control Box
(Front Panel)
⑤
②
③
④
①
Button part : It consists of UP button, DOWN button, PG button, If the
①
UP button is pressed, the entire motion simulator moves
upward, and when the DOWN button is pressed, the entire
motion simulator moves downward.
When UP or DOWN button is pressed, the simulator is
switched to manual mode, PC connection operation is stopped,
and all LEDs of the status LED are turned on. In case of
emergency, it is used as a stop button.
If the UP and DOWN buttons are operated before the RUN LED
※
on the motion simulator's status LED turns on, it may operate
outside the driving range of the motion simulator, and in this
case, equipment errors may occur.
In case of PG button, this button is used to upgrade the board
inside the control box. (Since the method can be changed with
a button other than the PG button, please refer to the
homepage if there is an upgrade notice.)
USB : This is a USB B TYPE connector for use when connecting to a
②
PC. It is recommended that the USB cable is equipped with a
ferrite and that the length is within 3 meters
