3.1
3.2
3.3
3
4.1
4.2
4
2
MOTION
CM-35 ELECTRONIC CURTAIN MOTOR
MOTION
CM-35 ELECTRONIC CURTAIN MOTOR
Pair a remote control that is able to program blinds. See pages 6 and 7
for remote controls details. In this manual CM-12 is displayed.
Shortly press the
program
button on the
motor. The blind will start stepping, indicating
that program mode has been activated.
(The blind remains stepping until the program
mode is de-activated.)
Repeat steps 3.1 - 3.3 to remove a blind from
a channel.
Press the
pair
button on the back of the remote
control to pair the blind to the selected channel.
The blind will shortly stop stepping indicating
that the remote has been paired to the blind.
Select a desired channel for the blind using the
channel selection
button on the remote control.
Channel
Selection
Pair
button
Channel
indicator
Pair a remote
IMPORTANT:
When the mains cable is permanently connected, a readily accessible disconnect
device must be incorporated externally to the motor.
When there is a pluggable connecter installed on the mains cable, the socket-
outlet must be installed near the motor and shall be
easily accessible.
Connecting diagram
Shortly press the
down
button to check if the
blind moves the right way: away from the
motor. If the blind moves the other way, the
rotational direction must be changed.
WARNING:
risk of damage.
Stop the blind before reaching
the end positions.
Check direction of rotation
Simultaneously press the
up
and
down
button
to change the direction of rotation.
Mains Cable 230V
120V
Neutral
Blue
White
Phase
Brown
Black
Ground
Yellow-green
Green
Program
button
Up
Down
End limits must be programmed to use a blind properly and to prevent it from being damaged.
Proceed to step 7 if end limits are already set.
English
14
15
