Thomson
Thomson PC-Series™ Precision Linear Actuator - Installation Manual - June 2014
10
4.7 Mounting of the unit using the mounting accessories
The unit can be shipped with mounting accessories mounted from the factory, in this case the
designation on the name plate and the ordering key (table T6.2.1) will help you determine which
accessory the unit is equipped with and which mounting instruction below to follow. Some of these
mounting accessories can also be ordered as seperate parts and be mounted to the actuator by the
customer. In this case you have to determine which accessories (see part number on the accessory
packaging labels) and actuator model (see the name plate) you have and select appropriate instructions.
If in doubt, contact customer support.
4.7.1 Spherical joint
To be able to mount a spherical joint the
extension tube must be equipped with a male
threaded rod end. Screw the joint on to the
rod end and secure it with the jam nut. Use a
solid pin to connect the joint to the load. Keep
in mind that any play between the pin and the
joint may affect the accuracy.
4.7.2 Front clevis
To be able to mount a separate front clevis the
extension tube must be equipped with a male
threaded rod end. Screw the clevis on to the rod
end and secure it with the jam nut.
A (REF.) *
B (REF.) *
C
D (Ø)
E (H9)
F
G
H
p/n
PC25
50
64
28
10
10.5
14
19
17
D607 406
PC32
50
64
28
10
10.5
14
19
17
D607 407
PC40
58
74
32
12
12
16
22
19
D607 408
* assuming 2 mm gap from jam nut to shoulder.
* assuming 2 mm gap from jam nut to shoulder.
A (REF.) *
B (REF.) *
C
D (Ø h11)
E (B11)
F
p/n
PC25
47
59
20
10
10
20
D607 409
PC32
47
59
20
10
10
20
D607 410
PC40
56
70
24
12
12
24
D607 411
