19
User
Manual
10.11.4
Adjusting rear wheel spacing
1
• Loosen the screws
(1) on below the rear
camber tube clamp (left
and right)
• Move axle bushing in or
out of the rear camber
tube. Never move the
buishing further then
indicated on top of the
bushing.
• Tighten the screws on
both rear camber tube
clamp (left and right)
Fig. 26
10.11.4.1
Changing rear camber
Loosen the screw (1) fig 26.1 below the rear camber tube
clamp (left and right)
Change or replace
both axle bushings
(2) fig 26.1 (0, 2, 4
or 6° angle)
Never install the
bushing further then
indicated on top of
the bushing.
Adjust the toe-in
toe-out of the rear
wheels (see section
10.11.5)
Tighten the screws
on both rear camber tube clamp (left and right)
10.11.5
Adjusting the toe-in/toe-out with rear
wheel camber.
Fig. 27
1
2
3
• Remove the rear wheel.
• Maintain the wheelchair
on a horizontal plane with
the support of the three
other wheels.
• Loosen screw of the rear
camber tube clamp (1)
(Fig. 27) while keeping a
bit of tension.
• Rotate the axle bushing
(3) so that the flat spot
is perpendicular to the
ground.
• Tighten the screw of the
rear camber tube clamp (1).
10.11.6
Adjusting the centre of Gravity
Remove the rear wheel.
Loosen the 2 bolts (1) of the wheel mounting tube on each side
of the wheelchair
Move the wheel mounting tube to the desired position
Tighten the 2 bolts (1) alternatively up to 10-12 Nm
10.12
Wheel Locks
10.12.1
Replacing/Adjusting the Wheel Lock
1
• Loosen screws (1) (Fig. 28).
• Slide the lock to the desired
position.
• Tighten screws (1) to a snug fit.
Final tightening should be done
manually.
• Once engaged, the lock should
embed 3 mm into the tire.
Fig. 28
10.13
Lock Extensions
10.13.1
Replacing/Adjusting the wheel lock
extensions
Fig. 28.1
1
• Loosen screw (1) (Fig. 28.1).
• Align eyelet with the mounting hole.
• Re-tighten screw (1) on the lock lever.
