Note: If you wish to use the vibration feature right away, please install the
batteries in accordance with section 6 prior to assembly.
2
1
2
3
4
preparation for use
3
Place the frame on the floor with the open
tubes pointing upwards.
Insert the ends of the backrest frame into
these open tubes.
The retaining buttons will 'click' through holes
in the lower tubes when properly located.
Lift the footrest frame to the upright position.
The seat cover has two ‘sleeves’.
Slide the larger of these over the backrest
frame bar and the smaller sleeve over the
footrest frame.
Press the footrest down towards the floor
until it locks into place, holding the seat
cover taut.
Pull bar (A) right around until it locks into place
against the hinges.
Next, lower the footrest frame.
When fully open, the frame will look as shown
in diagram 2 below.
