Fan Installation
(continued)
6
With fan safely suspended by bracket, make wire connections with wire nuts
included in hardware package as described in the Control Installation
Instructions. If using optional #003, #004 or #005 controls, the receiving unit
should be placed inside the arms of the hanging bracket and connected at this time.
Lift fan to ceiling and set half ball in the hanging
bracket so that the ridge on the edge of the
hanging bracket is seated in the slotted channel
in the half ball.
8
channel and ridge
Remove set screws on the sides of the hanging
bracket. Lift canopy to ceiling. With holes in
side of canopy aligned with set screw holes on
hanging bracket, reinstall set screws to hold
canopy in place.
9
set screw
Insert one blade into rotor slot. Using blade screws
from hardware package, secure blade to blade arm.
Start all three screws before completely tightening.
Repeat for all blades.
10
Attach bottom cap to fan body by aligning slots
on cap with fittings inside fan body, and rotating
clockwise, or proceed to Step 12 if you are using
the optional light kit.
11
WARNING
See Page 2
POWER OFF
Circuit Breaker