WARNING: DO NOT ATTEMPT TO OPERATE THIS APPLIANCE UNTIL YOU HAVE READ AND
UNDERSTAND ALL PRECAUTIONS. FAILURE TO DO SO CAN RESULT IN PROPERTY DAMAGE
SERIOUS INJURY, OR DEATH.
gas valve / bellows connection (Figure 8)
Page 10 of 15
cylinder / regulator connection (Figure 7)
Figure 6
BATTERY
LEAK TEST
WARNING:
1. Please observe proper polarity and use the correct battery type when installing or replacing the
battery. Improper installation could result in ignition failure.
2. Please remove the battery if consumed or if product is to be left unused for a long period of time.
1. Always perform the leak test as described below before lighting this appliance or each time the
cylinder is connected for use.
2. Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3. Conduct the leak test outdoors in a well-ventilated area.
4. Do not use matches, lighters or a flame to check for leaks.
5. Do not use this appliance until any and all leaks are corrected. If you are unable to stop a leak,
disconnect the propane supply and call a gas appliance service shop or your local propane gas
supplier.
To prevent fire or explosion hazard when testing for a leak:
Make sure the control knob is in the “OFF” position. Unscrew the push button cap on the ignitor module
located on the control panel to access the battery compartment. The ignitor module requires one AAA
size battery (Battery Included) (see Figure 6).
Operation
LIGHTING INSTRUCTIONS
1. Make sure control knob is in the "OFF" position.
2. Turn LP cylinder gas valve to fully open position.
3. Press down control knob and turn it counter
clockwise to "ON/MIN" position.
4. Push in gas control knob all the way and hold.
Continue to press the ignition button for 15
seconds.
5. If the burner is not lit, press down the control
knob and turn clockwise to "OFF" position,
repeat from step 3 after 5 minutes.
6. When burner is lit, press down the control knob
and turn it to desired heat output position between
"MIN" and "MAX".
7. Press down and turn the control knob clockwise to
"OFF" position to shut down the appliance. Turn off
cylinder gas valve.
