Morton
®
Water Softener Installation & Operation Manual
13
Programming the Water Softener and Filter
FIG. 16
Low Salt LED Indicator
Display
SELECT button
DOWN button
RECHARGE button
UP button
FIG. 17
Program the Softener
When the power supply is plugged into the electrical
outlet, the model code and a software version number
(example: J3.9), are briefly shown in the display.
Then the words “PRESENT TIME” appear and “12:00
PM” begins to flash.
NOTE:
If “- - - -” shows in the display, press the
p
UP
or
q
DOWN button until the model code
(“oHy”) shows in the display. Then, press the
SELECT button to set, and change to the
flashing “SET TIME" display.
Step 1. Set Time of Day
If the words “SET TIME" do not show in the display,
press the SELECT button until they do.
1
. Press the
p
UP or
q
DOWN buttons to set the
present time. Up moves the display ahead; down
sets the time back. Be sure AM or PM is correct.
Low Salt Light / Clean Reminder
When the water softener is connected to electrical
power, the light on the control panel will operate as
follows:
=
Light flashing, with the time of day shown in
the display
- The salt monitor system indicates a
low salt level and needs to be set. See “Set Salt
Level” on Page 14.
=
Light flashing, with “CLEAn” flashing in the
display
(See Fig. 17) - Four months have elapsed
on the system’s timer since start up or the last
reset.
This is a reminder to use Morton
®
MWSC Water
Softener Cleaner three times a year. To reset the
timer, press any button on the control panel and
“CLEAn” will disappear. The light will stop flashing,
unless the system is also low on salt (see above).
FIG. 18
NOTE:
Press buttons and quickly release to slowly
advance the display. Hold the buttons down
for fast advance.
continued on next page
