Morso 1710 Insert, Инструкция по установке и эксплуатации

Страница: 4 / 24

44
Installation requirements vary in different districts, and the local building officials have the final
authorization to approve your installation. You should discuss the installation with them before
beginning. Please ask your dealer for further information.
1.0 Installation of your Morsø stove
Installation of woodburning stoves must be safe and legal.
If your Morsø stove is not installed correctly, it may cause a house fire. To reduce
the risk of fire, the installation instructions must be followed carefully. Contact the
local building officials about restrictions and installation inspection in your area.
Before you start installing your stove, make sure that:
- The stove and chimney connection are placed far enough from combustible materials to
meet all clearance requirements.
- The floor protection must be adequate and must be made correctly according to the re-
quirements.
All neccessary approvals are needed from the local building officials.
The data plate, which is located on the back of the stove, provides information regarding safety
testing information, name of certified testing laboratory, and installation requirements.
There are numerous ways of building a
chimney. We will just describe a couple of
mountings of the insert.
The MORSØ 70 insert can be installed as
described below. The 70 can also be used
as a build-in stove with masonry/chimney
construckted for the size of the outer steel box,
as shown on the front page of this manual
. Remove the existing damper, if there is one.
(Fig. )
. It is easier to make adjustments to the
mansonry surrounding the insert, when the
heavy cast iron insert is not connected to
the steel box. (see item a-f page 5). Use the
steel box as a template for the mansonry
adjustments
3. It is important to leave a gap of few
millimeters between the steel box and the
mansonry because of increasing size when
warmed up.
If possible leave 5-30 mm. and fill up the
gap with heat resistant insulation material.
As shown in figure A, the steel box must
project 0 mm. from the mansonry. The steel
box should be adjusted by support
Dimensions in milimeters