The Specialist In Drum Handling Equipment
Models 525-N-114, 525-T-114 & 525M-T-114
Vertical-Lift Drum Pourer, Scale-Equipped,
106”, Air Power Lift and Tilt
Operator’s Manual for Morse Models 525-N-114, 525-T-114 and 525M-T-114
with Serial Number 249855 to ______
morsedrum.com
Copyright 2022 - Morse Mfg. Co., Inc.
Form OM525-114 (249855-______)
(Updated 24 Feb, 2022)
4
Controls
The Morse Vertical-Lift Drum Pourer is manually propelled and steered. The hydraulic
pump is powered by a vane type air motor. The air motor is control by a momentary
air valve located on the air motor. Attach air supply to the air valve. There are two
functions for the operator to control (Figure 3.1):
1. LIFT and lower function for vertical positioning of the drum.
•
To raise the drum, hold the air valve handle in the on position and raise the
LIFT handle. Release the two valve handles when desired drum height is
reached.
•
To lower the drum, push in the LOWER handle. Air motor is not needed.
2. TILT function to control the degree of rotation of the drum.
•
To tilt the drum forward for pouring, hold the air valve handle in the on
position and raise the TILT handle. Release the two valve handles when
drum angle is reached.
•
To return the drum to vertical position, hold the air valve handle in the on
position and push down on the TILT handle.
WARNING
- Watch out for pinch points
Stay clear of moving parts. Operator should remain
behind the push handle during the lift operation.
Floor Lock
Floor lock handle is located on left side of push handle. Pulling floor lock handle
toward operator until it locks in down position activates the floor lock. When floor lock
is activated it prevents unwanted free wheeling of unit. Floor conditions determine
effectiveness of floor lock. Operator should verify its holding action before depending
on it to hold.
Drum Holder Assembly
MORCINCH
TM
Drum Holder assembly (“saddle”) is the component on Vertical-Lift Drum Pourer intended to hold drum. Carriage assembly
moves vertically along mast to position drum holder assembly at correct height to secure drum around it’s middle using cinch chain and
ratchet tightening system.
The MORCINCH
TM
Drum Holder accepts accessories to handle plastic drum, fiber drum, or a smaller diameter drum.
Scale
Scale is simple to use and to read enabling accurate batching by weight. Touch pads include numbers for tare entry. Four load cells
accurately sense weight regardless of drum tilt angle. Battery saving “sleep” mode turns indicator off when scale is not in use.
“T” Type
Intrinsically safe
scale indicator for
use in hazardous
areas.
“N” Type
scale indicator
NOT for
hazardous
environments.
N-Type Scale
Economical general purpose instrument for
use in a variety of weighing applications.
NOT for use in hazardous areas. Powered
by six ordinary alkaline D-cell batteries.
T-Type Scale
Features an intrinsically safe, ultra low
power intensity (ULPI) indicator for use
in many hazardous areas, approved for
all classes, groups in division 2 of N.E.C.
hazardous environment classifications. The
hand pumped or air powered drum handler
with this intrinsically safe weighing system
may be used in many hazard areas where
ordinary electric powered equipment would
be prohibited.
Figure 3.1
