The Specialist In Drum Handling Equipment
Model 400A-72SS-117
Stainless Steel Hydra-Lift, 72”,
AC Power Lift & Tilt
Operator’s Manual for Morse Hydra-Lift Karrier Model 400A-72SS-117
Serial Number 400000 to ______
morsedrum.com
Copyright 2022 - Morse Mfg. Co., Inc.
Form OM400A-72SS-117 (400000-______)
(Updated 26 Sep., 2022)
4
Figure 3.1
WARNING
- Watch Out for Pinch Points
Stay clear of moving parts. Operator
should remain behind the push handle
during the lift operation.
Floor Lock
The step-down floor lock is located behind the base (figure
3.1). To activate, step down on the floor lock until it locks
in down position. When floor lock is activated it prevents
unwanted free wheeling of unit. Floor conditions determine
effectiveness of floor lock. Operator should verify its holding
action before depending on it to hold.
Drum Holder Assembly
The MORCINCH
TM
Drum Holder (Saddle) assembly is the component
on intended to hold the drum. It is designed to secure a standard
ribbed 55-gallon (210 liter) steel drum around it’s middle using a cinch
chain and ratchet tightening system. It automatically adjusts for 22” to
23.5” (56 to 59.7 cm) diameter drum.
The MORCINCH
TM
Drum Holder also accepts accessories to handle a
plastic drum, fiber drum, or a smaller diameter drum.
Figure 2.3
Motor Information
Motor is dual voltage and can be wired for 1-phase 110V 50Hz or 1-phase 220V
50Hz. Motor does NOT come with switch, cord or plug. Consult an electrician
to install and wire according to local codes.
Controls
There are two functions for the operator to control (Figure 2.3):
1. “
LIFT
” and lower function for vertical positioning of the drum
2. “
TILT
” function to control the degree of rotation of the drum
1. LIFT and Lower Function
To raise the drum
a. Plug the motor into power supply.
b. Turn the motor on by holding the momentary switch in the on position.
c. With the motor on, raise the LIFT handle.
To lower the drum
a. With the motor off, push in the LOWER handle.
2. TILT Function
To tilt the drum forward for pouring
a. Turn on the motor by holding momentary switch in the on position.
b. With the motor on, raise the tilt handle.
To return the drum to vertical position
a. Turn on the motor by holding momentary switch in the on position.
b. Push the tilt handle down.
