The Specialist In Drum Handling Equipment
MODEL 15-SS
Stainless Steel Can Tipper
Operator’s Manual for Morse Model 15-SS Stainless Steel Can Tipper
Manufactured 05/2006 to ______
www.MORSEmfgco.com
Copyright 2008 - Morse Mfg. Co., Inc.
Form PL15-SS (0506-____) (Updated June 17, 2008 3:10 PM)
2
Safety Information
(continued)
DANGER
- Indicates a situation which, if not avoided, will result in serious injury or death.
This signal word is limited to the most extreme situations.
WARNING
- Indicates a situation which, if not avoided, could result in serious injury or
death.
CAUTION
- Indicates a situation which, if not avoided, can result in damage to the machine.
WARNING
- Do Not Modify the Unit. Under no circumstances should any modifications be made to the Morse
machinery without factory authorization. Any modifications may void the warranty. This machine was designed
to perform a specific job and alterations may result in injury to operator or machine.
WARNING
- No Loose Fitting Clothing Wear close-fitting clothing and safety equipment appropriate to the job.
Loose fitting clothing may become caught on the machinery and cause severe personal injury.
CAUTION
- Wear safety shoes with non-slip soles and hard toe protection.
CAUTION:
DO NOT exceed weight
capacity of 75 Lb.
Assembly Instructions
Unpack and identify the following parts:
1.
1 - Can Holder with Catch
1 - Base Assembly
1 - Center Brace
6 - 1/4-20 x 5/8 Panhead Screws
6 - 1/4-20 Two Way Lock Nuts
Spread the base assembly open, hinging at the base
2.
riveted joints (see curved arrow A in parts diagram).
Fasten the center brace in place using four screws and
3.
nuts as shown. Tighten securely.
Rotate the can holder ring to horizontal position, hinging
4.
at the holder riveted joint, with the catch upright as shown
(see curved arrow B in parts diagram).
Place the can holder between the uprights of the base as
5.
shown. Insert screws (from inside of ring) through holes in
the can holder ring and through the base uprights. Thread
the nuts onto the bolts but do not tighten completely. The
nuts should be just loose enough to allow the can holder
to pivot freely.
Place a few drops of oil on the pivot bolts before using
6.
and reapply oil periodically to minimize wear.
Maintenance
Periodically inspect all moving parts, framework, and
1.
contact areas for signs of wear, fatigue, or loosening.
