22
9. DECOMMISSIONING
1. STORAGE
Long-term storage - If you will not be using the unit for an extended
period of time (more than a few weeks) it is best to clean the unit and dry
it out completely. Please store the unit per the following steps:
1.
Press power button to switch off and unplug the unit.
2.
Drain the remaining water from the unit.
3.
Clean the filter and let the filter dry completely in a shaded area.
4.
Collect the power cord at the water tank.
5.
Re-install the filter at its position.
6.
The unit must be kept in upright position when in storage.
7.
Preserving the machine in ventilating, dry, non- corrosive gas and safe
place indoor.
ATTENTION:
The evaporator inside the machine has to be dried out before the unit is
packed to avoid component damage and mould. Unplug the unit and place it
in a dry open area for days to dry it out. Another way to dry the unit is to set
the humidity point more than 5% higher than the ambient humidity to force
the fan to dry the evaporator for a couple of hours.
Bad
functioning
Is the air filter clogged?
Clean the air filter as instructed
Is the intake duct or discharge
duct obstructed?
Remove the obstruction from the
discharge duct or intake duct.
No air intake Is the filter clogged?
Wash the filter
Loud noise
when
running
Is the machine put in the plat
place?
Put the machine on the plat ground
Is the filter clogged?
Wash the filter
E2
Humidity sensor problem
Change a sensor
LO
Environmental humidity is
below 20%
The dehumidifier shuts down for
self- protection
HI
Environmental humidity is
above 90%
CL
Low temperature protection,
the environmental temperature
＜
5
℃
CH
High temperature protection,
the environmental temperature
＞
35
℃
