Under Low power, Medium power and High power setting, the heater will keep
working controlled by thermal cut-out.
Note:
The higher the power is, the quicker the desired temperature will be achieved
but the power consumption will be higher.
Lower power levels are recommended when the heater is being used for an
extended period of time.
Eco mode
Press the Power/Mode button (c), until the
“ECO” light turns on.
Under Eco mode, the heating power will adjust automatically when the room
temperature is approaching the setting temperature.
Example: The setting temperature is 25
℃
. When the room temperature is less
than 22
℃
, the heater will work under High power (
). When the room
temperature rises to 23
℃
, the heater will change to work under Medium power
(
). When the room temperature rises to 24
℃
, the heater will change to
work under Low power(
). When the room temperature reaches to the
setting temperature 25
℃
, the heater will switch off automatically. And when the
room temperature is lower than setting temperature, the heater will switch on
again under Eco mode.
Remark: if no thermostat setting, the default temperature is 23
℃
under Eco
mode.
Thermostat setting
t
Only under Eco mode, can you make the thermostat setting.
Desired temperature setting range:10
°C--30 °C
1. Press the Power/Mode button (c), until the
“ECO” light turns on.
2. Press the thermostat button (a), the temperature digit will blink.
3.
Use the “+” and “-” [b] and [e] buttons to set the desired temperature.
4. The setting temperature digit will stop blinking and the current room
temperature will appear after the desired temperature is set.
5. The heater will maintain the air temperature in the room by switching on and
off automatically.
Timer: Auto power on
Note: This function should only be set if you require the heater to be
automatically turned on after a certain period of time (1 to 24 hours from the
time the function is set). You can only make the timer power on setting under
Stand-by mode.
1. Press the on/off power switch [F] to turn the appliance on. The light on( )
will turn on. The appliance will be in Stand-by mode.
2. Press the Timer button(d), the light on( ) will turn on, and the start hour
digit (0.0) will blink.
